Rola 59310 Guía De Instrucciones página 8

ASSEMBLY INSTRUCTIONS
59307 1-1/4 in. / 59308 2 in. Base Units
LOADING BIKES
Securing by the front wheel:
1. Be sure rotating arm assembly (G) is on the front cradle tube side (D).
See page 6 figure 4 for reference. Place rotating arm assembly (G) in
the "unlocked" position. Depress grip trigger and move grip up shaft to
maximum height. FIG 1.
Note: It may be easier to remove grip completely, depending on bike
style.
2. Lift bike onto carrier and position front wheel on front wheel tube
cradle (D). FIG 2. While supporting bike with one hand, rotate arm
assembly upward over wheel. Center "V" shape in hook over wheel
near fork and pull downward on grip to secure FIG 3.
Note: With some fork/wheel combinations, arm assembly may actually
lock in the vertical position, but this is not necessary.
3. If you are unsure that you have pulled down hard enough on grip, push
down on the grip lever, which will move the grip downward one more
detent. Lock the grip. FIG 4.
4. Secure rear tire by aligning rear cradle strap (F) with rear axle of
bike. Place strap through spokes (rotate tire as needed) and slide into
buckle. Pull downward on strap. FIG 5.
NOTE: If your strap is too short, or if you have a fat tire bike, replace
with longer strap (P) (supplied). Refer to page 12 for strap replacement
instructions.
5
1
2
3
4
F
Rear cradle
strap
PAGE 8 59307_59308_59310_IN_Rev A • Questions? (800) 234-6992 • RolaProducts.com
H
Grip
Maximum height
Rotating arm
assembly
Front wheel tube with cradle
G
Rotating arm
assembly
H
Grip
Grip lever
Grip triger
Grip lever
G
D
Grip triger