Vimar ELVOX RS11 Manual De Instalación Y Funcionamiento página 24

Complete procedures for learning the travel for automatic gate systems with double swing leafs, without slowdown.
- Fully adjust the trimmer TR4-V.RALL (clockwise).
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Release pushbutton P1
- Activate APCH: The first gate leaf opens at normal speed
- When the gate leaf reaches full opening activate APCH: the second leaf will open at normal speed
- When the gate leaf reaches full opening activate APCH: the second leaf will start closing at normal speed
- When the gate leaf reaches full closure activate APCH: the first leaf will start closing at normal speed
- When the gate leaf reaches full closure activate APCH
- Activate APCH: the first gate leaf starts opening and as soon as you decide that the gate leaf offset time is enough, activate APCH again: the second gate
leaf will start moving
- Activate APCH: the second gate leaf starts closing and as soon as you decide that the gate leaf offset time is enough, activate APCH again: the first gate
leaf will start moving
- Wait for the DL8 LED to switch off.
- Learning successfully completed.
Rapid procedures for learning the travel for automatic gate systems with a single swing leaf, with slowdown (motor output M1).
The single-leaf procedures allow you to configure a gate with a single leaf
WITH SLOWDOWN
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Release pushbutton P1
- Activate APCH: The first gate leaf opens at normal speed
- When you want the gate to move more slowly activate APCH
- The slow speed phase begins
- When the gate leaf reaches full opening activate APCH: the first leaf will start closing at normal speed
- When you want the gate to move more slowly activate APCH: the slow speed phase begins
- When the gate leaf reaches full closure activate APCH
- Wait for the DL8 LED to switch off.
- Learning successfully completed.
Rapid procedures for learning the travel for automatic gate systems with a single swing leaf, without slowdown (motor output M1).
- Fully adjust the trimmer TR4-V.RALL
- Close the gate fully.
- Press and hold learning pushbutton P1 for at least 3 seconds
- The DL8 LED starts flashing
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Do not release the P1 button and hold it down for 3 seconds
- The DL8 LED starts flashing faster
- Activate APCH: The first gate leaf opens at normal speed
- Activate APCH: The first gate leaf opens at normal speed
- When the gate leaf reaches full opening activate APCH: the first leaf will start closing at normal speed
- When the gate leaf reaches full closure activate APCH
- Wait for the DL8 LED to switch off.
- Learning successfully completed.
Note: After a reset or after feeding the card, the run time of the first maneuver of closing is increased by about 50 sec, to allow the completion of move-
ment in each case.
22
EN