Worx WG500.1 Manual De Instrucciones página 8

the appliance from the power supply
when not in use, before servicing, when
changing accessories such as blades, and
the like.
16) Store idle Appliances indoors - When
not in use, appliances should be stored
indoors in dry, and high or locked-up
place - out of reach of children.
17) Maintain Appliance With care -
Keep cutting edge sharp and clean for
best performance and to reduce the
risk of injury. Follow instructions for
lubricating and changing accessories.
Inspect appliance cord periodically,
and if damaged, have it repaired by
an authorized service facility. Inspect
extension cords periodically and replace
if damaged. Keep handles dry, clean, and
free from oil and grease.
18) check Damaged Parts - Before further
use of the appliance, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function. check for alignment of moving
8
parts, binding of moving parts, breakage
of parts, mounting, and any other
condition that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center unless
indicated elsewhere in this manual.
SAVE THESE iNSTRucTiONS
All-in-one Blower/Vac/Mulcher
Table 1
Minimum gauge for extension cords
Volts Total length of cord in feet
120V 25
240V 50
Ampere rating
more than not
more than
0-6 18
6-10 18
10-12 16
12-16 14
NOTE: Only the applicable parts of the Table
need to be included. For instance, a 120-
volt product need not include the 240-volt
heading.
Figure 1
Method of securing extension cord
APPLIANCE CORD
CORD
SeT
FOR All DOuBlE-iNSulATED
APPliANcES
1) Replacement Parts
When servicing use only identical
replacement parts.
2) Polarized Appliance connections
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade is
wider than the other) and will require the use
of a polarized extension cord. The appliance
plug will fit into a polarized extension cord
only one way. If the plug does not fit fully
50 100 150
100 200 300
AWG
16 16 14
16 14 12
16 14 12
Not
12
recommended
(A) TiE cORD AS
SHOWN
(B) cONNEcT PluG
AND REcEPTAclE
EN