Cosatto HOLD Manual Del Usuario página 6

straps through the required slots in the seat (e) then refasten the shoulder strap ends to
the harness connector.
There are two positions for the crotch strap. To move the crotch strap, release the crotch
strap clip underneath the child car seat (f) and push the clip through the slot in the child
car seat and child car seat liner (g). Refit the Crotch strap by pushing the crotch strap clip
through the desired slot (h). Open out the crotch strap clip and pull back on the strap to
locate the clip to the bottom of the seat.
6 - correct position of shoulder straps
Adjust the height of the shoulder straps so they are level with, or just below child
shoulders. If in any doubt always use the slot above the shoulder rather than below it.
7 - changing the handle position
The handle can be placed in 4 different positions:
1. Fitted in the vehicle position
2. Carrying position
3. Stow position
4. Steady position
To change positions, push the button (a) on both sides of the handle and move the
handle rearward or forward.
8 - securing your child car seat
Put the handle in the position for fitting the child car seat to the vehicle (Position 1 in
Step 7). Place the child car seat onto the vehicle seat - rearward facing.
Pass the lap strap of the vehicle safety belt through the front strap guides (a). The lap
strap should fit below the blue stickers on the front strap guides.
Pass the vehicle seat diagonal belt through the guide on the back of the child car seat
(b). The blue sticker on the guide should be visible when the diagonal belt is fitted.
Ensure the strap fits under the handle (c).
Tighten by pulling the diagonal vehicle seatbelt that normally travels across the
passenger's chest and fasten the vehicle seat belt (d).
Ensure that the child car seat is secure.
IMPORTANT: The position of the seat belt/lap strap buckle can affect the stability of the
child car seat. In an accident this could stop the child car seat from protecting your child
as well as it should. If, when the seat belt/lap strap belt is properly tightened, the buckle
lies in the position marked then try fitting the child car seat in another seating
position in your vehicle.
9 - fitting and using the hood
Noting the orientation of the hood bar (a), fit the hood by pushing the arms into the
hood hinges on each side of the seat (b) until they lock in place, secure the hood fabric
to the hood by fastening the press stud on both both side (c).
Removal of the hood is the reversal of this procedure.
Before adjusting the hood, put the carry handle in the vertical position. Raise the hood
until it locks in the up position (d). Push the hood back to lower (e).