Schlage Control FE410F Instrucciones De Instalación página 4

Install the Lock
1
Install the bolt and latch.
Caution: Use provided bolt!
1a Adjust bolt length, if necessary.
Measure the backset.
2C\," (60 mm)
OR
2C\v" (70 mm)
If the measurement is 2C\v" (70 mm), extend the bolt.
Twist the
faceplate.
1b If desired, change to the square-corner faceplate.
1. Use a flathead screwdriver
to pry the faceplate off.
The faceplate for the latch can be changed in the same way.
L
1c Install the firecup into the lower hole.
DO NOT install the firecup on a 1C\," thick door.
L
Fire cup not
required for
deadbolt hole
Opening should
face the outside
of the door.
Make sure the button
pops into place.
2. Press the square-corner
faceplate into place.
1d Install the bolt and the latch into the door.
If the bolt does not remain retracted throughout installation,
locking and unlocking could be reversed, resulting in an
unsecured residence.
Make sure the word
TOP faces up when
installing the bolt.
Make sure latch bevel
faces strike plate.
2
Install the top part of the lock.
2a Install the outside deadbolt assembly on the outside of
the door.
If the bolt does not remain retracted throughout installation,
locking and unlocking could be reversed, resulting in an
unsecured residence.
Clips hold the assembly
on the door.
CAUTION
Actual Size (4)
CAUTION
Route the cable over
the deadbolt and
through the door.
Route the tailpiece through
the slot in the bolt.
3