Electric Connections - Ribind SUPER 2200 FAST Manual De Instrucciones

G G
B B

ELECTRIC CONNECTIONS

- A -
CONNEXIONS
Obligatory software version 07 FAST or following
versions FAST.
ELECTRONIC BOARD KS V.07 FAST
J1 EXP. Connector for EXPANDER card
J2 SEC.TRANSF. Connector for secondary transformer
J3 L 1 - N Power supply 230 Vac 50/60 Hz
PRI.TRANSF.
J4 Connector for primary transformer
J5 DO NOT TOUCH THE JUMPER !IF IT IS
REMOVED THE OPERATOR DOESN'T MOVE !
J6 SEC.LOCK Connector to the manual release safety device
ENCODER
J7 Not available
CAPACITOR
J8 Connector to the capacitor
J9 Connector for limit switch connection
LSO
Limit switch contact stopping the motor opening
COM.
Contacts common unit
LSC Limit switch contact stopping the motor closing
MOTOR
J10 Connector for Motor
J11 Blinker (max. 40W )
J12 AERIAL Radio Antenna
COM Contacts common unit
PHOT.1 NC
Photocells contact (NC)
J13 INVERTER NOT APPLICABLE
STOP
J14 Contact of the stop button (NC)
OPEN Contact of the opening button (NO)
CLOSE
Contact of the closing button (NO)
K BUTT.
Contact of a single impulse (NO)
A*A 24 Vac accessories power supply
SIGNAL
Warning light - gate open 12Vdc
BUZZER
Buzzer - Wiring acoustic warning (12Vdc max
200 mA) - PAY ATTENTION TO THE POLARITY -
RADIO
J15 Connector for radio receiver 24Vac
HEATER
J16 Heater Card Connector
J17 INVERTER NOT APPLICABLE
TRIMMER
R2 To adjust the speed of the deceleration, both in
LOW SPEED opening and closing
TRIMMER
R9 To adjust the force of the operator through
TORQUE the electronic clutch
code BC07050