Reverse Door Swing - KENMORE ELITE HE5 Steam 110.9772 Manual De Uso Y Cuidado

A combination of pipe fittings must be used to connect the
dryer to the existing gas line. Shown is a recommended
connection. Your connection may be different, according to
the supply line type, size and location.
A
B
³⁄₈
A. " flexible gas connector
B. ³⁄₈ " dryer pipe
C. ³⁄₈ " to ³⁄₈ " pipe elbow
D. ³⁄₈ " pipe-to-flare adapter fitting
3. Open the shutoff valve in the supply line. The valve is open
when the handle is parallel to the gas pipe.
A
A. Closed valve
B. Open valve
4. Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show a
leak. Correct any leak found.

Reverse Door Swing

You can change your door swing from a right-side opening to a
left-side opening, if desired.
NOTE: For ease of installation, you may want to use 2 or more
people to remove and reattach the dryer door.
Remove the door
1. Place a towel or soft cloth on top of the dryer or work space
to protect the surface.
2. Open the dryer door. Remove the 5 screws that hold the door
hinge on the front panel of the dryer.
A
C
A. Dryer front panel
B. Dryer door
C. Screws
3. Remove the door.
4. Lay the dryer door on a flat, protected surface with the inside
D
C
5. Lift the inner door assembly off of the outer door assembly.
Reverse the hinge
1. Place the inner door, screw head side up, on the work space.
2. Remove the 4 hinge screws that hold the hinge to the door
B
3. Move the large hole screw to the opposite side. Remove the
B
4. Move hinge to the other side and reattach with the 4 screws
5. Set the inner door assembly aside.
door assembly facing up.
Remove the 5 screws to release the outer door assembly
from the inner door assembly, as indicated below. See
illustration. It is important that you remove only the
5 indicated screws.
Set the outer door assembly aside.
and remove hinge.
A
A
A. Hinge side screw
B. Locator pins on hinge
C. Top side screw
2 plug screws and plastic plugs, and insert them in the
original screw holes on the opposite side.
A
A. Hinge screws
B. Large hole screw
C. Plug screws and plastic plugs
removed in Step 2. Make sure locator pins line up in holes
and drive the top 2 screws in place first to help drive locator
pins into proper location.
B
C
C
B
B
C
13