Remote Control - GE APDA14 Manual Del Propietario Y Instrucciones De Instalación

Controls

Remote Control

the signal receiver on the air conditioner.
the remote control that could block the signal.
Power On/Off
1.
Mode
2.
Cool: LED lights when in cooling mode.
Dehumidification: LED lights when in dehumidification
mode.
Fan: LED lights when in fan mode.
Heat: LED lights when in heat mode (applies only to
heat and cool modes).
Fan Speeds
3.
Select between multiple fan speeds. Number of fan
speeds vary by model. In dehumidification mode, and
room temperature is greater than 77° F, fan speed can
be adjusted; Otherwise fan speed is fixed to "low".
On/Off Timer
4.
To set the timer for a 1- 24-hour delay until the air
conditioner turns off:
1. When you use the timer setting button while the unit is
operating, you can preset a time for the unit to turn off.
2. When you use the timer setting button while the unit
is on standby, you can preset a time for the unit to
turn on.
3. If you press the "ON/OFF" button, the preset timer
function will be canceled.
4. Timer setting range is 1-24 hours.
To clear Timer Delay program:
NOTE: Air conditioner can be either on or off.
1. Press the Timer Button.
2. Press the + or - buttons continuously till "00"
appears to cancel the timer function.
To change the remaining time (in hours):
1. Press the Timer Button.
2. Press the plus or minus button to change the delay
time from 1 to 24 hours.
3. The new delay time will display.
Setting the Temperature
5.
raise or lower the temperature. The temperature can be
raised or lowered in the cool mode. The temperature
cannot be adjusted in fan or dehumidification mode.
NOTE; The temperature can be set between 61° F to
89° F (Cool Mode) and 61° F to 77° F (Heat Mode).
49-7836-1
feet.
as indicated on the remote control.
1
3
4
5
2
5