Working With The Power Tool; Preselecting The Speed - Flex SE 125 18.0-EC Instrucciones De Funcionamiento Originales

Continuous operation with engaged switch
rocker
NOTE
Following a power failure, the switched-on
electric power tool will not start running again.
 Push the switch rocker forwards and
engage by pressing the front end.
Switch off the machine
 To switch off the power tool, release
the switch rocker by pressing the rear end.

Preselecting the speed

 To set the operating speed, press the
speed control button. Selected speed is
maintained even when switching off.
 Gently press the switch to accelerate the
power tool up to the preselected speed.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
24
NOTE
Overload protection: switches the
–
machine off in the event of overload.
– Sensor-controlled temperature
monitoring: If there is a risk of overheating
the machine switches off.

Working with the power tool

WARNING!
The rotating sanding disc must not come
into contact with sharp projecting objects.
Danger of kickback! Damage to sanding pad.
If the sanding pad is damaged or severely
worn, it must be replaced.
CAUTION!
Hold the electric power tool with both hands!
1. Attach sanding tool.
2. Check position of the guard.
3. Connect dust extraction system.
4. Switch on dust extraction system.
5. Switch on the power tool.
6. Place electric power tool on the work
surface. The brush ring must be flush
with the work surface.
7. Increase the pressure to bring the
sanding pad into contact with the work
surface. In doing so, slew the electric
power tool with overlapping movements.
8. Sanding in corners:
– Switch off the power tool and wait until
the sanding tool has come to a
standstill.
– Pull out pivoted edge segment and
swivel to left.
SE 125 18.0-EC