Instructions For Use; Inserting/Replacing The Battery; Attaching The Auxiliary Handle - Flex SE 125 18.0-EC Instrucciones De Funcionamiento Originales

SE 125 18.0-EC

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.

Inserting/replacing the battery

 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.

Attaching the auxiliary handle

The auxiliary handle can be attached to
improve handling of the electric power tool.
 Remove fastening screw from the left side
of the grip hood.
 Screw in and tighten auxiliary handle.
When removing the auxiliary handle, put
back the screw which was removed
beforehand.
21