Troubleshooting - Stanley SHP 2150 Instrucciones De Montaje, Cuidado Y Uso

CARE AND MAINTENANCE

TROUBLESHOOTING

If you have any questions regarding the product, please call customer service at 1-866-508-1330
PROBLEM
Unit will not turn on.
The unit is running
but there is no water
flow.
Why is water leaking
where the high
pressure hose connects
to the spray gun?
The power washer
turns on for
2 seconds, shuts off,
and will not turn
TROUBLESHOOTING
back on. Do I have a
defective unit?
14
93908_16ANR030_2150_ENG-FR-SP.indd 14
CORRECTIVE ACTION
1. Make sure the power washer is in the "OFF" position. Plug in the electrical cord to a
grounded 120 volt outlet (no electrical extension cord should be used). If the electrical
cord will not plug into your outlet, your electrical outlet is not properly grounded and
should not be used. Use another electrical outlet.
2. If this did not correct the problem, try plugging into another electrical outlet and
repeat the above procedure. If it is still not working, call Customer Service at 1-866-
508-1330.
1. Check the water source. Unclog the nozzle on the lance. (See nozzle cleaning
instructions under "Cleaning nozzles".) Or take off the nozzle and just spray out of
the spray gun and lance. This will indicate if the problem is with the nozzle.
1. Make sure there is an o-ring at the end of the metal tip of the high pressure hose. If
no o-ring is present, the connection between the hose and spray gun will leak. O-Ring
replacements are included in the package contents.
1. It sounds like your power washer is working just fine. When the water is connected,
the accessories are assembled properly, and the power switch is turned on, the power
washer may turn on for 1 - 2 seconds to prime the pump. It automatically shuts off
and waits for the spray gun trigger to be pressed. When the trigger is pressed, water
starts flowing through the pump. The water sensor in the pump "senses" the moving
water and automatically turns the power washer on.
2. Turn the power switch to off, hold in the trigger on the spray gun, so that you have a
steady stream of water. While you are holding the trigger open on the spray gun, at
the same time, turn the power switch on.
16/12/23 下午1:05