Storage And Transport - 3M DBI-SALA 2104710 Manual Del Usuario

6.0 MAINTENANCE, SERVICING, STORAGE
6.1 CLEANING: Periodically clean the Sliding Beam Anchor's metal components with a soft brush, warm water, and a mild soap
solution. Ensure parts are thoroughly rinsed with clean water.
6.2 WEAR PAD REMOVAL AND INSTALLATION: The Wear Pads are the only user serviceable component of the
Sliding Beam Anchor. Figure 10 illustrates replacement of the Wear Pads. If inspection reveals cracked or worn pads,
perform the following steps to remove the old pads and install the new replacements pads.
1. Insert a fl at head screwdriver between the top of the plastic Wear Pad and the End Clamp.
2.
Slide the screwdriver around to the front of the Wear Pad and pry out the end. Insert the screwdriver between the
bottom of plastic Wear Pad and the End Clamp. Slide the screwdriver around to the front of the Wear Pad and pry out
the end.
3. Pry out the bottom of the Wear Pad and remove it from the End Clamp. Dispose the old Wear Pad.
4. Slide the new Wear Pad in the End Clamp. Apply pressure to snap the new Wear Pad into place.
6.3 SERVICE: Only 3M or parties authorized in writing by 3M may make repairs to this equipment. If the Sliding Beam Anchor
has been subject to fall force, it must be removed from service immediately, clearly marked "DO NOT USE", and then
destroyed. If inspection reveals an unsafe or defective conditions, remove the system from service and contact 3M
regarding replacement or repair.
6.4 STORAGE AND TRANSPORT: When not in use, store and transport the Sliding Beam Anchor and associated fall
protection equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may
exist. Thoroughly inspect components after extended storage.
7.0 LABELS
Figure 11 illustrates labels on the Sliding Beam Anchor. Labels must be replaced if they are not fully legible.
10