Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. . Ensure that the supply socket:
2
rated current as set out on the rating plate; c) complies with the IEC regulations:- differential thermal-
magnetic switch (also known as ground fault interrupter) with In = rated value as stated on the rating
plate; - differential with Id sensitivity = 30 mA.
room. . Make sure the environment is suitable for the power supply cable provided. The cable of the
4
appliance is H05 VVF, designed for internal use. For installation in other than internal settings, it will be
necessary to replace the cable with the appropriate type (for example H07 VVF for external settings).
5
. Insert the plug in the socket (do not use three-way adapters and reduction adapters).
equipment has been transported or stored overturned, let is rest in its correct position for at least 3 hours
before hooking it up to the mains (see fig. 5).
8. CONTROLS
The appliance features controls situated in a protected panel on one of the machine's sides.
lifting switch:
to open and close the cover - Position II to lift - Position O to stop - Position I to lower.
2. Light switch:
to switch on the internal lights.
unit.
4. Thermometer:
to read the temperature inside the appliance.
temperature setting. a) Press key
changed by pressing key
6 "UP"
9. CHECKING CORRECT OPERATION
Make sure that: . the plug is connected;
1
3
. thermometer shows the desired temperature for the goods to be stored;
direct sunlight or to powerful lamps;
(climatic class 4); . there are no direct air draughts in the appliance, owing to the presence of doors,
6
windows, fans or conditioner outlets.
10. REPLACEMENT OF THE LAMP
1.
Open the cover.
2.
Switch off the appliance
place. . Remove the lamp socket, whilst holding the fluorescent tube and its protective cover. . Pull the
4
protective cover out of the other lamp socket.
following the above instructions in reverse order (see fig. 7).
Operator's guide
a) is properly earthed; b) fulfils the requirements of the
3
. Ensure that there is no danger of explosion (AD) in the
3. Refrigeration switch:
5 "SET or P"
once to display the temperature set-point, which can be
or
7 "DOWN"
(see fig. 6).
2.
the refrigeration unit switch is on (green light lit up);
5.
ambient temperature does not exceed +30°C with 55% R.H.
. 3.
Remove the screws securing one of the lamp sockets in
6.
Replace the fluorescent tube.
7
(A)
N.B.:
if the
1. Cover
to switch on the refrigeration
Thermostat:
to adjust the
4.
appliance is not exposed to
5
7.
Refit all components by
I
attached
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Tabla de contenido
