Sencotel Granitore 1 Manual De Empleo página 73

After that, put off both the main switch and mixer switch and unplug the ma-
chine.
Fig.30
7.2. Disassembling the dispensing tap
Before removing the bowl it is recommended to disassemble the tap; after
cleaning the tap must not be reapplied until the bowl has been correctly posi-
tioned in its seat.
Disassemble the tap removing the pins from its seat to release all the other
parts. Push the "push lever dispenser until contact with the tank and pull up-
wards as shown in the figure:
These components may be placed in a basin containing hot water (approx.
50°C); Therefore it is possible to perform a carefully wash. as shown in section
7.4.
SL320005700 Ed.01 - 01-2014
Fig.31
Fig.32
Never disassemble the tap if the product or any other liquid is
present inside the bowl.
7.3. Removing the bowl and the lid
Removal of every machine bowl is fundamental to ensure correct machine
cleaning and sanitization.
To remove a bowl correctly proceed as follows:
1 remove the lid as shown at paragraph 6.1.
2 raise the front part of the bowl to release it;
Fig.33
3 remove from its seat the bowl with the seal (B) by pushing and tapping
lightly on the rear part;
Fig.34
4 take out the auger and remove the seal (A).
- 15 _EN-