Rinsing Cycle - Sencotel Granitore 1 Manual De Empleo

Introduce the auger, engaging head (C) with shaft (D).
Fig.39
Note: rotate the auger to engage it.
Pushing the front part, set the bowl with the seal attached (B), in the place
Fig.40
Slightly raise head (C) of the auger so that it meets the seat provided (E) in
the bowl.
Fig.41
SL320005700 Ed.01 - 12-2013
Press the bowl downward until it engages the surface as shown in the figure.
Follow these instructions to refit the tap:
1 using the vaseline provided, adequately lubricate the joint and the hooks
2 lean the pins on its seat and push the "push" lever dispenser until introduce
the tap.
Note: Correctly install the components as shown in the figure.
The non-lubrication of the cap may cause product leakage from
the tap.

7.6. Rinsing cycle

Before starting up the machine, you must carry out the rinsing cycle.
Proceed as follows:
1 fill the tank with clean water
2 let the machine on for 5 minutes in the "agitation" mode only
3 turn off the machine and empty the tank by opening the tap
Fig.43.a
Fig.43.b
- 17 _EN-
Fig.42