Settings; Frost Protection; Shutting Down; Maintenance And Care - Kärcher AWT Manual De Instrucciones

Drawing water
 Insert a coin in the coin slot.
 Press the water dispenser button.
 Hold the fuel pump nozzle in
the container opening.
 Pull the fuel pump nozzle lever
until the desired filling level has
been reached.
Checking tyre pressure
 Insert a coin in the coin slot.
 Press the tyre pressure button.
 Secure the valve connector on
the tyre valve.
 Read the tyre pressure at the
pressure gauge.
 Increase the tyre pressure by
pressing the "+" button.
or
 Decrease the tyre pressure by
pressing the "–" button.
 Remove the valve connector.
 Pull on the hose briefly and
feed the hose via the automatic
hose reel.

Settings

Setting the run time
Note:
The adjustable run time applies to the in-
sertion of one of the following coins:
– 50 Eurocents
– 50 British pence
– 1 Swiss franc
– 1 Polish złoty
– 5 Norwegian Kroner
Customer Service can set up different
types of coins.
1 Rotary knob
 Adjust the run time per unit at the P I ro-
tary knob.
Possible setting range: 30 seconds to
7 minutes.
Note:
Rotary knobs P II, P III and P IV have no
function.

Frost protection

Device with frost protection
1 Frost protection switch
2 Frost protection heater
 Turn the frost protection switch "ON" at
temperatures below +5 °C.
ATTENTION
Risk of damage due to frost. The frost pro-
tection heater is active only when the main
switch is also "ON".
Note:
The frost protection heater is not thermo-
stat-controlled. When switched on, the
heater is continuously in use.
Device without frost protection
In a device without frost protection, a shut-
down must be carried out if there is risk of
frost

Shutting down

 Shut off water supply.
 Drain the condensate in the com-
pressed air reservoir (see "Mainte-
nance tasks").
 Set the main switch to the "OFF" posi-
tion.
Shutdown during Frost Conditions
 Shut off water supply.
 Remove water from the device and sup-
ply line.
 Drain the condensate in the com-
pressed air reservoir (see "Mainte-
nance tasks").
 Set the main switch to the "OFF" posi-
tion.

Maintenance and care

Daily
 Empty the coin cassette (see "Mainte-
nance tasks").
 Check the general condition of the de-
vice.
 Check the condition of the valve con-
nector.
 Check status of hose pipes.
 Open the lower cover and check the
condition of the compressor.
 Have damaged parts replaced.
Weekly
 Clean the external surfaces of the appli-
ance.
 Drain the condensate in the com-
pressed air reservoir (see "Mainte-
nance tasks").
2
-
EN
Maintenance Works
Emptying the coin cassette
1 Door
2 Coin cassette
 Open door.
 Remove and empty the coin cassette.
Drain off the condensate.
1 Cover
2 Condensate drain valve
 Remove cover.
 Hold the condensate drain valve over a
duct or a collection container.
WARNING
Risk of injury from the water stream.
Never direct the water jet on human beings,
animals, the appliance or electrical parts.
 Open the condensate drain valve slow-
ly and drain the condensate.
 Close the condensate drain valve.
 Replace cover.
7