Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C
LEANING THE
P
ATIENTS
The mask system (excluding the swivel and
short tube) is validated for multipatient use.
Clinicians should refer to the Masks
Disinfection/Sterilization Guide for details.
To clean the headgear between patients,
use the method described in the previous
section "Cleaning the Mask in the Home".
R
EASSEMBLING THE
See Figure E.
1 Insert the mask cushion into the groove
of the mask frame (Fig. E-1). Fit the top
section first and then work your way
around, pushing the mask cushion into
the mask frame.
Note:
The diamond markers on the mask
frame and on the mask cushion (one on
top, two at the bottom) must line up.
2 Push the ports cap onto the mask ports
(Fig. E-2).
3 Attach the vent cover to the mask
elbow. To do this, insert the elbow into
the ring of the vent cover (Fig. E-3).
Push the ring to the top so that the vent
cover is over the back of the elbow.
Then, press the lip of the vent cover to
ensure that it is securely seated in the
groove of the elbow.
4 Connect the short air tubing to the mask
elbow.
5 Connect the swivel to the main air
tubing, ready for next use (Fig. E-4).
M
ASK BETWEEN
M
ASK
A
I
DDITIONAL
NFORMATION
R
EASSEMBLING THE
Note:
You do not need to disassemble the
headgear for cleaning. However, if you choose
to do so, the reassembly procedure is
explained in this section.
When disassembled, the headgear has four
parts:
A: Left strap, B: Middle strap,
C: Crossover buckle, D: Right strap
1 Lay out the four parts of the headgear as
shown in Figure F-1.
2 As shown in Figure F-2, thread the
straps BR and BL through the crossover
buckle (Part C).
3 Thread strap BR through the buckle on
Part A. Thread strap BL through the
buckle on Part D (Fig. F-3).
4 Thread the straps of Part A and Part D
through the buckles on Part B (Fig. F-4).
5 With the headgear clip facing down, fit
the headgear clip onto the hole on the
headgear. While pressing the headgear
tab down, rotate the headgear clip away
from the tab to lock it into place
(Fig. F-5). Repeat this with the other
headgear clip.
T
S
ECHNICAL
PECIFICATIONS
P
–F
C
RESSURE
LOW
See Figure A.
H
EADGEAR
URVE
Tabla de contenido
