Removing The Mask; Cleaning The Mask In The Home; Disassembling For Cleaning - ResMed Mirage Kidsta Nasal Mask Guía De Usuario

R
EMOVING THE
To remove the M
IRAGE
one of the headgear clips. This releases one
side of the headgear from the mask. Pull the
mask and headgear away from your head.
Notes:
Do not pull the headgear off your head
•
without releasing the headgear clips first.
You can detach the elbow from the mask
•
frame while wearing the mask. This is
useful when therapy needs to be stopped
for a short time; for example if you need to
go to the bathroom.
Check that you can remove the headgear
•
clip, the quick release swivel or the
headgear unaided.
D
ISASSEMBLING FOR
See Figure D.
1 Detach the mask elbow. To do this,
squeeze the sides of the mask elbow at
the finger grips while pulling it away from
the mask frame (Fig. D-1).
2 Disconnect and separate the main air
tubing, short air tubing, mask elbow and
vent cover (Fig. D-2).
Notes:
To prevent damage to the short air
•
tubing, disconnect it by holding it at the
cuff.
The swivel does not need to be
•
disconnected from the short air tubing.
3 Detach the headgear from the mask
frame by squeezing and releasing both
headgear clips.
4 Remove the ports cap from the mask
frame (Fig. D-3).
5 Firmly pull the mask cushion away from
the mask frame (Fig. D-4).
M
ASK
, squeeze
K
IDSTA
C
LEANING
C
LEANING THE
H
OME
Notes:
Wash the headgear before first time use,
•
as the dye may run. It is important to
always handwash the headgear.
The headgear may be washed without
•
being disassembled.
D /A
AILY FTER EACH USE
Handwash the mask components in
lukewarm, soapy water. Use pure soap
(an example of pure soap is Dove
unscented; made by Unilever). Rinse the
components well and allow them to air dry
out of direct sunlight.
W
EEKLY
Handwash the headgear in warm, soapy
water. Use pure soap. Rinse well and allow
it to air dry out of direct sunlight.
CAUTIONS
.
Do not use solutions containing
•
bleach, chlorine, alcohol, aromatics,
moisturisers, antibacterial agents, or
scented oils to clean any part of the
mask system or air tubing. These
solutions may cause damage and
reduce the life of the product.
Do not expose any part of the mask
•
system or tubing to direct sunlight as
it may deteriorate.
If any visible deterioration of a mask
•
component is apparent (cracking,
crazing, tears etc.), the mask
component should be discarded and
replaced.
M
ASK IN THE
soap,
®