Milnor MWF27J8 Mantenimiento página 38

Ocultar thumbs Ver también para MWF27J8:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Chapter 3. Routine Maintenance
Maintenance Components—Large Extractors
3.1.6.
Figure 13: Oil Maintenance Areas for Bearing Assembly
1.
Oil drain port. When you remove the used oil, remove spilled oil.
2.
Oil fill tube and stopper. Do not let new oil get on drive components. After you change the oil,
secure the fill tube and vent tube behind the motor mount bracket as shown.
3.
Housing vent tube
4.
Seal cavity drain tube. Remove comtamination that flows from the tube.
5.
Grease relief port. Remove grease that flows from this port.
.
Figure 14: Grease Ports for Oil-filled Bearing Assembly with Seal Grease Maintenance. See also
Figure
13.
Grease Lubrication Plate 01-10025W
.
Supplement 3
Milnor washer-extractors with a rubber spring suspension also have shock absorbers. The shock
absorbers have a different type of connection than those for automobiles. It is not necessary to
replace the shock absorbers at specified intervals. It is only necessary to replace them if there is
an indication that they are damaged or very worn.
PELLERIN MILNOR CORPORATION
Views of Maintenance Areas
Legend
1.
Seal grease port
2.
On machines with grease plate 01-10025W,
the seal is the only bearing assembly
component that uses grease. The bearing
housing is oil-filled. See
requirements.
About the Shock Absorbers
34
[Document BIWUUM03]
Legend
Table 4
for oil
Tabla de contenido
loading

Este manual también es adecuado para:

Mwf27z8

Tabla de contenido