Milnor MWF27J8 Mantenimiento página 26

Chapter 3. Routine Maintenance
Table 3: Filters, Screens, and Sensitive Components
Remove contamination from these components to prevent damage and unsatisfactory performance.
Mark
Do this each
1 2 3 4 5 6
x 40 to 60 hours inverter fans, vents, filters
x 600 hours
x 2400 hours
x day*
x 2400 hours
x 2400 hours
x 200 hours
Table 4: Fluid Containers
Examine. Add fluid if necessary and keep components clean to prevent damage.
Mark
Do this each
1 2 3 4 5 6
x 600 hours
Table 5: Components that Become Worn
Examine. Tighten or replace if necessary, to prevent shutdowns and unsatisfactory performance.
Mark
Do this each
1 2 3 4 5 6
x 200 hours
x 200 hours
x 200 hours
x 200 hours
PELLERIN MILNOR CORPORATION
Component
motors
entire machine
chemical inlet areas
water inlet strainers if
supplied by others
strainer in water regulator for
optional supply injector and
pumped chemicals on some
models.
strainer for steam inlet.
(Steam is optional on some
models.)
Component
bearing housing
Speak to your dealer for replacement parts
Component
drive belts and pulleys
tubes and hoses
rubber springs
shock absorbers
22
More Data. See also Section 3.1.3 "How
to Remove Contamination"
See Figure 8. Keep good air flow.
Keep good air flow.
Remove excessive dust and dirt.
Some chemical supplies that stay on machine
surfaces will cause corrosion damage. See
Figure 9 and Section 2.2. "Prevent Damage
From Chemical Supplies and Chemical
Systems"
Remove strainers from incoming water lines
and flush with water.
See Figure 10
See Figure 12
More Data. See also
"Lubricant Identification and Procedures"
remove used oil. Add 22 ounces (650 ml) of
oil 30 (Table 10). See Figure 13
More Data
See Supplement 1 and Figure 7
Examine hoses and hose connections for
leaks.
See Figure 15
See Supplement 3 and Figure 15
Section 3.1.4