FLO-DYNAMICS CCST 288 Manual Del Usuario página 14

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Use the arrow keys (↓↑) to select the required vehicle brand and press ENTER to confirm.
The display will now show the various models (for example, if the brand chosen was FORD):
Use the arrow keys (↓↑) to move to the model required and press ENTER to confirm. The
following will appear on the display:
Where "w:yz" refers to the quantity for the vehicle selected. The machine will be ready to enter
the correct quantity of refrigerant. Confirm by pressing the ENTER key. Please contact your
retailer if you wish to install the DATABASE ADVANCED (DBA).
Open the high-pressure tap on the machine and press the START key (in the case of an A/C
system with a single high or low-pressure coupling, open only the relative tap on the machine).
NOTE: Charging may not run to completion due to pressure balance between the internal
bottle and the A/C system. If this occurs, close the high pressure tap (leaving the low-pressure
side open), and switch on the A/C system. The unit is equipped with a bottle heater to limit this
occurrence. When the charging operation is complete, the machine will display:
Close the high- and low-pressure taps. Start the vehicle engine and switch on the A/C system,
allowing both to run for at least 3 (three) minutes. At this point the system will be at steady
state and it will be possible to check the high and low pressure values on the relative pressure
gages. Disconnect ONLY the high-pressure quick-connect coupling (if necessary, switch the
engine off). Then, with the A/C system still running, open the high and low-pressure taps to
enable the A/C system to absorb the refrigerant contained in the hoses. Allow about one
minute, then remove the low pressure coupling of the machine from the vehicle A/C system
and switch the engine off. Turn the main switch (i) to OFF (0).
NOTE: When working with A/C systems with a single high-pressure
charging quantity 3 oz. (100g) in excess of the required quantity, since in this case it will be
impossible to recover the residual refrigerant from the hoses after charging.
INSTRUCTIONS MANUAL
<ALFA ROMEO>
AUDI
BMW
CHRYSLER/JEEP
<COUGAR>
ESCORT
ESCORT D
FIESTA
VACUUM
20 MIN
<FILLING
w:yz G>
GAS FILLING
End of filling
procedure
Press RESET
-14-
(RED)
coupling, set the
Tabla de contenido
loading

Productos relacionados para FLO-DYNAMICS CCST 288

Tabla de contenido