FLO-DYNAMICS CCST 288 Manual Del Usuario página 11

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Use the arrow keys (↓↑) to select the required vehicle brand and press ENTER to confirm.
The display will now show the various models (for example, if the brand chosen was FORD):
Use the arrow keys (↓↑) to select the model required and press ENTER to confirm. The
following will appear on the display:
where "w,yz" refers to the amount of refrigerant for the vehicle selected. The machine will be
ready to enter the correct quantity of refrigerant. Confirm by pressing the ENTER key. Please
contact your retailer if you wish to install the DATABASE ADVANCED (DBA).
Open the high and low pressure taps on the machine and press the START key to begin the
refrigerant
recovery/recycling
"Recovery/Recycling". During this phase, the LCD will display the quantity of refrigerant
recovered. Upon completion of recovery, the machine will stop and automatically discharge
the used oil extracted from the A/C system during the recovery phase. The oil discharge
operation lasts 4 to 12 minutes and depending on the ambient temperature. If any residual
refrigerant is left in the A/C system, as indicated by an increase in pressure during the oil
discharge phase, recovery will automatically restart.
Upon completion of discharge, the machine will check the presence of air into the bottle, and if
it's necessary to purge the non condensable gases, the alarm will sound continuously and the
display will show:
The CCST288 will automatically purge non-condensable gases (NCGS) if excess NCGS are
detected at the end of recovery. Allow the unit to complete this procedure to reduce the risk of
comebacks that can be caused by charging excess NCGS into an A/C
The machine will automatically go on to running the vacuum phase for the preset time. Upon
completion of the vacuum phase, the machine will stop, emit a beep, and display:
At this point, open the new oil tap and add the needed quantity. When completed, close the
new oil tap and press START to go on to charging the quantity of refrigerant set previously.
NOTE: Charging may not run to completion due to pressure balance between the internal
bottle and the A/C system. If this occurs, close the high pressure tap (leaving the low-pressure
INSTRUCTIONS MANUAL
<ALFA ROMEO>
AUDI
BMW
CHRYSLER/JEEP
<COUGAR>
ESCORT
ESCORT D
FIESTA
VACUUM
20 MIN
<FILLING
w:yz lb>
phase,
which
will
AIR PURGE
Recovery gas
x:xx lb
Bp: xx psi
T: xx °F
OIL INJECTION
Press START
to continue
-11-
be
indicated
on
the
system.
LCD
as
Tabla de contenido
loading

Productos relacionados para FLO-DYNAMICS CCST 288

Tabla de contenido