Hrc1 - Count-Up; Hrc2 - Count-Down; Interruption / End Of Training; Restart Of Training - Kettler SF1B Instrucciones De Entrenamiento Y Manejo

Training and Operating Instructions
24
GB
Training by pulse defaults
(PROGRAM) "HRC1 Count Up"
• Press "PROGRAM" until symbol: "HRC Count Up"
flashes.
• Press "SET": Default range
Or
Start training, all values count up.
Power is increased automatically, until the target
pulse is achieved (e.g. 130)
(PROGRAM) "HRC2 Count Down"
• Press "PROGRAM" until symbol: "HRC Count
Down" flashes.
• Press "SET": Default range
The entries and possibilities for modifications are
analogue to program item "Count Down".
Or
Start of training
Note:
In the HRC programs the determination of the initial
power of 25-100 watts is possible in the default
range.
• Enter values with "Plus" or "Minus" (e.g. 100)
Power is then automatically increased from 100
watts on, until the target pulse is achieved (e.g.
130)
Pulse
• The pulse value can still be changed at this point
(readiness for training) with "Plus" or "Minus",
e.g. from 130 to 131.
Start of training by pedaling.
Comment:
• For HRC programs, KETTLER recommends pulse
measurement with the chest strap.
• There is a power adjustment with HRC programs
for deviations of +/– 6 heartbeats.
Interruption or end of training
For less than 10 pedal revolutions/min or pressing
"RECOVERY", the electronic equipment recognizes
an interruption of the training. The training data
achieved are displayed.
Display.
Note:
Speed, revolutions and pulse are represented as aver-
age values with the Ø symbol.
• In this display, no current pulse is available.
With "Plus" or "Minus" the display changes to the
remaining values of defaults (here DISTANCE 1.50,
ENERGY 87, TIME 4:09, last set power 125 and
current pulse 110.
Display.