Installation To The Tank - GOK GWD Instrucciones Par El Montaje Y El Funcionamiento

INSTALLATION TO THE TANK

Assembly insert
After having DETERMINED THE ADJUSTING DIMENSION X, the insert must be locked.
• Connecting threads present on the tank larger than G1 can be brought to the connecting
thread G1 of the insert by using commercially available reducers. Due to the partial
increase of the fitting edge, the following is applicable: X = a + k + k
Part No. 15 382 57 a
Limit indicator GWG - type GWD -issue 2
Insert G 1/2
• Set the determined adjusting dimension X.
• Clamp probe tube
fitting by hand or using a jaw spanner so that the probe tube
cannot be moved.
Insert G 3/4
• Loosen the locking screw
• Set the determined adjusting dimension X.
• Tighten the locking screw
be moved.
Screw-in insert G 1
• Loosen the upper locking screw
a
• Set the determined adjusting dimension X.
• Tighten the locking screw
probe tube
• Screw-in the tank screw-in insert into the tank
• Tighten the upper locking screw
Tank installation plate D70 for cap nut
• Measure the determined adjusting dimension X from the lower
edge of the tank panel and adjust (according to the instruction
of the respective tank manufacturer).
• Assembly according to the attached installation instructions
15 143 50
Insert level gauge FSA
• Loosen the locking screw
• Set the determined adjusting dimension X.
• Tighten the locking screw
be moved.
• Observe the assembly and operating manual 15 276 50 and
table 3 on the page below.
using the cap nut of the compression
on the insert.
so that the probe tube
in such a way that the
cannot be moved.
on the insert.
so that the probe tube
.
.
Reducer
cannot
cannot
7 / 12