Kenmore 137.23671310 Manual De Uso Y Cuidado página 8

Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does not occur in 5 seconds, turn the burner
controls OFF,wait 5 minutes and repeat the lighting
procedure. If the burner does not ignite with the valve
open, gas will continue to flow out of the burner and
could ignite with risk of injury.
Match Lighting
ADo not lean over grill while lighting.
1. Open lid during lighting.
2. Place match into match holder (hanging on right front leg). Light
match, place into lighting hole on left side of firebox.
3. Turn right knob to HI position. Be sure burner lights and stay lit.
4. Light other burners follow with step 3.
Sideburner Match Lighting
1.Open sideburner lid. Turn on gas at LPcylinder.
2. Place lit match near burner.
3. Turn sideburner knob to HL Be sure burner lights and stays lit.
8" 23671-46477279
Burner Flame Check
Remove cooking grates and heat diffusers, Lightburners, turn
knobs from HI to LO. You should see a smaller flame in LO
position than seen on HI. Perform burner flame check on
sideburner, also. Always check flame prior to each use. If only
low flame is seen refer to "Sudden flame drop or low flame" in
the Troubleshooting Section.
HJ
LO
Turning Grill OfF
* Turn all knobs to OFF position. Turn LPcylinder off by turning
hand-wheel clockwise to a full stop.
Igniter Check
" Turn gas off at LPcylinder. Pressand hold electronic igniter
button. "Click" should be heard and spark seen each time
between collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
* Important: Make sure gas is off at LPcylinder before checking
valves. Knobs lock in OFF position. To check valves, first pushin
knobs and release, knobs should spring back. if knobs do not
spring back, replace valve assembly before using grill Turn
knobs to LOW position then turn back to OFF position. Valves
should turn smoothly.
Hose Check
* Before each use, check to see if hosesare cut or worn. Replace
damaged hoses before using grill. Use only
valve/hose/regulator as specified in the parts list of this Use&
Care Guide.
General Grill Cleaning
Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong
solution of detergent and water or use a grill cleaner with scrub
brush on insides of grill lid and bottom. Rinseand allow to
completely air dry. Do not apply a caustic grill/oven
cleaner to painted surfaces.
" Porcelain surfaces: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution
or specially formulated cleaner. Use nonabrasive scouring
powder for stubborn stains.
" Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy waten Wipe dry with a soft
n.onabrasive cloth.
" Stainless steel surfaces: To maintain your grill's high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad. Use only in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
• Cooking surfaces: If a bristle brush is used to clean any of the
grill cooking surfaces, ensure no loose bristles remain on
cooking surfaces prior to grilling, it is not recommended to
clean cooking surfaces while grill is hot.
REV 2