Introduction - Diamatic 08013A, 08014A Libro De Instrucciones

ENGLISH
EN
WARNING: Severe burn or injury could occur if you touch the hot muffl er or exhaust pipe. Do not touch
the hot muffl er or exhaust pipe.
WARNING: Any alterations or modifi cations of this machine could result in damage to the machine or
injury to the operator or other bystanders. Alterations or modifi cations not authorized by
the manufacturer voids any and all warranties and liabilities.
WARNING: To avoid injury or property damage, do not leave the machine where it can be tampered with
or started by persons untrained in its operation. You must have training in the operation of
this machine before using it. DO NOT leave the machine running unattended.
WARNING: Substantial damage to the fl oor, the machine, or personnel may result if the machine is
operated with the pad off center, damaged or missing. Do not operate the machine if the
pad is off center, damaged or missing.
WARNING: Operating a machine that has loose parts could result in injury or property damage. Do not
operate this machine if there are loose parts. Inspect the machine for loose parts frequently.
This will promote safe operation and a long life for the machine.
WARNING: Vibration from machinery may cause numbness or tingling of the fi ngers in certain people.
Smoking, dampness, diet, and heredity may contribute to the symptoms. Wearing warm
clothing, gloves, exercising and refraining from smoking can reduce the effects of vibration.
If the symptoms still persist, discontinue operation of the machine.

This propane fl oor care equipment is manufactured in two
basic concepts: the buffer/burnisher and the fl oor stripper.
Both of these designs are truly PORTABLE equipment.
Propane buffers are best defi ned as ultra high speed buf-
fers with the staying power to produce superior high gloss
fl oor surfaces. Upon contact with the fl oor, the buffer
should always be kept moving. The speed at which you
walk will determine the results that you will obtain. Slower
speeds create more heat and therefore more shine. A
moderate pace is recommended for best results and safe
operation. NEVER RUN WITH THE BUFFER!! While
a credible shine will still result, the danger of trying to
stop the machine in an emergency situation is unaccept-
able. When buffi ng, avoid loose tile, electric outlets, door
thresholds and any object which may come in contact with
the pad other than the fl oor itself. REMEMBER, the pad
is turning very rapidly.
Proper care and maintenance will protect your investment
and keep your machine serving you for many years to
come. It is essential that these issues are closely fol-
lowed:
CAUTION: Overfi lling the propane tank is the
number one cause of problems with
a propane machine. This can cause
the engine to run poorly or not at all.
- 12 - FORM NO. 71511A
In addition, overfi lling allows liquid propane to
enter the fuel control system, possibly ruining
the lockoff/regulator assembly. This voids the
warranty on affected parts of the machine. To
avoid problems, read and understand fully, the
section "Filling and Storing Propane Tanks."
OVERHEATING is a major cause of engine failure.
Keep the cooling air bonnet fi lter clean. Protect your
machine; don't allow wax dust/lint to build up on the
cooling fi ns of the engine cylinder(s). A good high
pressure spray wash directed at the fi ns when the
engine is cold will prevent this from happening.
LOW OIL AND DIRTY OIL account for most of the
other failures. It's recommended to change the oil on
a regular schedule, perhaps exceeding that which is
found in the engine manufacturers' manual. Checking
the oil daily, before putting the machine to work, is a
good habit to get into and could save you the down-
time and expense of replacing the engine due to oil
starvation. AFTER AN OIL CHANGE, MAKE SURE
YOU HAVE REPLACED THE OIL SUPPLY BEFORE
RESTARTING THE ENGINE.
BLASTRAC Operator's Manual (EN) - Concrete Polisher