Idiomas disponibles
Idiomas disponibles
3) Setting the Motion Detection Sensitivity
Click the 'Sensitivity Setup' button to display the 'Activity Blocks' to set the sensitivity. The 'Activity
Blocks' will superimpose on the moving object to highlight the activities on the video screen. You can
adjust the sensitivity by using the sensitivity control box. Click the up button to increase the sensitivity
and click the down button to decrease the detection sensitivity.
The sensitivity value displayed in the control box, is an arbitrary value, indicating the relative detection
sensitivity. Adjust the sensitivity by monitoring the 'activity blocks' on the screen to make sure that the
sensitivity is optimally adjusted for motion detection and without false alarm. The user can use the
'Show within detection area' button to confine the 'activity blocks' to the selected detection areas.
4) Setting the Detection Interval
The occurrence of motion is the detected by correlating the successive video frames. In the "Detection
Interval" control box you can adjust the detection interval between these successive frames. The
detection interval is set in units of 100mS. The default value is at 200mS.
5) Recording Time Extension
The motion detected in the detection area(s) will be used as an event to trigger the alarm recording of
the corresponding camera. Once the recording has started, it will continue recording even after the
motion has stopped (= recording time extension).
This extension time can be adjusted by using the 'Post motion rec.' control box. The time interval is
indicated in seconds and is shown in the control box. The default value is 3 seconds.
6) Enabling the Motion Detection Function
Click the 'Motion Detection Enable' box to enable the motion detection function once you have set all the
parameters. (User can temporarily disable the motion detection by unchecking the 'Motion detection
enable' box. All settings of the motion detection will stay unchanged, which makes it easier for the user
to re-enable the motion detection afterwards). Click the 'Close' button; the corresponding camera button
in the display panel will light up with a yellow grid to indicate that the motion detection function has been
enabled. The detection area will be shown in the video screen if the 'Show at all times' button is
clicked.
VCC2
Yellow grid indicates that
the motion detection is
enabled.
6
VELLEMAN
