Cleaning And Maintenance - cecotec CONGA 1790 VITAL Manual De Instrucciones

ENGLISH
Before operating the robot under Spiral cleaning mode, place it on the spot to be cleaned.
Press the spiral cleaning button on the App.
Fig. 25
Edge mode
When this mode is selected, the robot will clean along walls and around furniture (table or
chair legs, for example).
Press the edge cleaning button on the App.
Fig. 26
Room mode
The robot will carry out a cleaning cycle under Auto mode and then will return to the starting
point.
Press the room cleaning button on the App display.
Fig. 27
To ensure an efficient cleaning of the room, close the door.
Suction power level function
Select the desired robot's suction power during the cleaning process. There are 3 suction
power levels: Turbo, Normal and Eco. The power level function can also be turned off if you
wish to use the Wet & dry tank for scrubbing only.
Fig. 28
Scrubbing intensity levels function
Select the desired water intensity level during the scrubbing process. There are 3 water levels:
High, Medium or Low. The scrubbing intensity function can also be turned off if you wish to use
the Wet & dry tank for sweeping only.
Random mode
The robot will start cleaning randomly and will return to the charging base smartly when it
runs out of battery. The robot will not create maps under this mode.
This mode can be activated from the App.
Manual mode
The robot can be moved manually using the direction buttons on the App.
Cleaning scheduling
This robot includes schedule settings in order for you to customise the cleaning cycles. The
robot can be scheduled through the App.
42

4. CLEANING AND MAINTENANCE

In order to lengthen your robot's shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
Empty the dust in the Wet & dry tank.
Press the Wet & dry tank's release button.
Fig. 29
Open the dust compartment and empty it.
Fig. 30
Cleaning of the robot's filter
Remove the filter.
Carefully shake off all dust from the filter.
Fig. 31
Cleaning of the free-fall sensors
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
Warning: Do not spray cleaning products directly on the sensor.
Fig. 32
Cleaning of the main brush
Slightly press the main brush frame's tabs in order to open the main brush storage gap and to
remove it.
Fig. 33
Remove any hair, fluffs or dust collected in the brush and around the axes.
Fig. 34
Clear and clean the robot's suction channel.
Fig. 35
Reinstall the main brush and its frame.
Fig. 36
High-efficiency filter
The high-efficiency filter is designed with fibres that help trapping dust particles, dust mites,
pollen... It is very important to clean periodically the filter, to avoid these particles from building
up in the filter, causing efficiency loss. It is convenient to carry out this maintenance once a
week.
It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendations: Dirt can be removed with a small brush or by shaking it carefully against a
hard surface for dust to fall off. The high-efficiency filter cannot be washed.
ENGLISH
43