Idiomas disponibles
Idiomas disponibles
SPRINGS
SPRINGS
CLEARANCE
HOLE
9. Finish ceiling.
Cut an opening in finished ceiling material for housing collar.
DO NOT INSTALL TRIM RING WHEN
LAMP
LAMP
BAFFLE IS ALREADY ATTACHED TO FAN.
BRACKET
BRACKET
10. Install optional trim ring to trim ring / baffle.
(Trim rings not included with Model 744L.)
Remove the cardboard protector from inside the housing collar.
Place trim ring over trim ring / baffle.
Place fingers directly above and below tab (as shown with arrows
and squeeze to snap tab securely to trim ring / baffle.
Repeat for each of the 4 tab locations.
FINISHED
CEILING
MATERIAL
HOUSING
COLLAR
TRIM RING / BAFFLE
TRIM RING / BAFFLE
TRIM RING / BAFFLE
TRIM RING / BAFFLE
TABS (4)
TABS (4)
TRIM RING
TRIM RING
DEV-10141
DEV-10141
MODELS 744L • 744RL • 744RNL
SPRINGS
LAMP
BRACKET
11. Attach trim ring / baffle to housing.
Use a pencil to insert one end of each spring into the holes on the
lamp bracket. Center trim ring / baffle in ceiling opening.
12. Install bulb.
(Bulb not included with Model 744L.)
CAUTION - RISK OF FIRE: 75W MAX. LAMP
Use R30, BR30, PAR30L, or PAR30LN lamps only (75W
Max.).
For wet locations (tub or shower) - use PAR30L or
PAR30LN (75W Max.) lamp only. Use no other lamp
types.
Do not install a lamp indentified for use only in enclosed
luminaries.
CAUTION: Disconnect power at service entrance
!
before cleaning, servicing, or selecting motor
speed.
Page 4
TRIM RING / BAFFLE
1100709D
