Philips AVENT SCD520 Manual De Instrucciones página 18

EngliSh
18
Question
Why does the parent unit
react slowly to the baby's
crying?
Why do the non-
rechargeable batteries of
the baby unit run low
quickly?
Why does the charging
time of the parent unit
exceed 8 hours?
The specified operating
range of the baby
monitor is 330
metres/1000 feet. Why
does my baby monitor
manage a much smaller
distance than that?
Why is the
connection lost every
now and then? Why are
there sound
interruptions?
What happens during a
power failure?
Is my baby monitor
secure from
eavesdropping and
interference?
Answer
The microphone sensitivity level of the baby unit may be set too high.
Decrease the microphone sensitivity level in the menu of the parent
unit.
The microphone sensitivity level of the baby unit may be set too low.
Increase the microphone sensitivity level of in the menu of the parent
unit.
The microphone sensitivity level of the baby unit may be set too high,
which causes the baby unit to transmit more often. Decrease the
microphone sensitivity level in the menu of the parent unit.
The volume on the baby unit may be set too high, which causes the
baby unit to consume a lot of energy. Decrease the volume of the
baby unit.
You may have set a maximum room temperature that is lower than
the actual room temperature or a minimum room temperature that
is higher than the actual room temperature. The baby unit continues
to send data to the parent unit and therefore uses more power.This
causes the non-rechargeable batteries of the baby unit to run low
quickly.
Perhaps you have switched on the nightlight. If you want to use the
nightlight, we advise you to run the baby unit on mains power.
The parent unit may be switched on during charging. Switch off the
parent unit during charging.
The specified range is only valid outdoors in open air. Inside your
house, the operating range is limited by the number and type of walls
and/or ceilings in between. Inside the house, the operating range is up
to 50 metres/150 feet.
The baby unit and the parent unit are probably close to the outer
limits of the operating range. Try a different location or decrease the
distance between the units. Please note that it takes about 30
seconds each time before a connection between the units is
established.
If the parent unit is sufficiently charged, it continues to operate during
a power failure, both inside and outside the charger. If there are
batteries in the baby unit, it also continues to operate during a power
failure.
The DECT technology of this baby monitor guarantees no
interference from other equipment and no eavesdropping.