Philips AVENT SCD520 Manual De Instrucciones página 15

accessories
Belt clip and neck strap
If the batteries of the parent unit are sufficiently charged, you can take the unit with you inside and
outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it
around your neck with the neck strap. This allows you to monitor your baby while you are moving
around.
Connecting the belt clip
1 Snap the belt clip onto the parent unit (Fig. 31).
Disconnecting the belt clip
1 Pull the belt clip off the parent unit.
Connecting the neck strap
1 Insert the end loop of the neck strap through the hole behind the strap post. Thread the
neck strap through the end loop and pull the neck strap tight (Fig. 32).
Disconnecting the neck strap
1 Pass the neck strap though the end loop and pull the end loop out of the hole behind the
strap post.
Cleaning and maintenance
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit if it is connected to the mains and take the parent unit out of the
charger.
2 Clean the parent unit and the baby unit with a damp cloth.
Make sure the parent unit is dry before you put it back into the plugged-in charger.
3 Clean the charger with a dry cloth.
4 Clean the adapters with a dry cloth.
Storage
- When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and the rechargeable batteries from the parent unit. Store the
parent unit, the baby unit, the charger of the parent unit and the adapters in a cool and dry
place.
replacement
Baby unit
Batteries
Only replace the non-rechargeable batteries of the baby unit with four non-rechargeable 1.5V R6
AA batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.
adapter
Only replace the adapter of the baby unit with an adapter of the original type.You can order a new
adapter from your dealer or a Philips service centre.
EngliSh
15