KitchenAid Standard Manual De Instalación página 9

Remove the Gaskets
IMPORTANT: The gaskets contain strong magnetic strips. Follow
these instructions and keep screws and other loose metal parts
away from the gaskets to avoid damaging them.
1. Begin at the top right corner. Slowly pull the gasket out of the
corner and continue working slowly toward the opposite side
as shown.
2. Proceed slowly from corner to corner until the gasket is
completely free from the groove.
3. Gently push the gasket to the back of the drawer. Be sure to
keep all screws and loose metal parts away from the
magnetic gasket as shown.
A
A. Drawer front
B. Gasket
4. Repeat the process for the other gasket.
B
Install the Custom Overlay Panels
IMPORTANT:
Before installing the custom overlay panels, be sure to install
any custom hardware. See "Hardware Installation (optional)."
Be sure to maintain a ³⁄₈" (9.52 mm) gap between the overlay
panel (top drawer) and the bottom of the kitchen cabinet.
1. Using a Phillips screwdriver or scribe, remove any residual
foam from the pre-drilled pilot holes.
A
A. Pre-drilled pilot holes
2. Using a Phillips screwdriver, remove the wiring plug cover for
the upper drawer as shown. Do not discard the screw or
cover. Set them aside for later use.
NOTE: Removing the wiring plug cover will allow for easier
access when drilling and attaching the drawer front to the
overlay panel. Be sure to replace the wiring plug cover when
installation is complete.
A. Wiring plug cover
B. Screw
A
A
A
B
A
9