Electrical Requirements; Unpack The Refrigerator Drawers; Important; Installation Instructions - KitchenAid Standard Manual De Instalación

If the floor of the opening is not level with the kitchen floor,
shim the opening to make it level with the kitchen floor.
24"
(60.96 cm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator drawers into the final location,
it is important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your refrigerator drawers be provided. Use an
outlet that cannot be turned off by a switch. Do not use an
extension cord.
IMPORTANT: If this product is connected to a GFCI
(Ground Fault Circuit Interrupter) protected outlet, nuisance
tripping of the power supply may occur, resulting in loss of
cooling. Food quality and flavor may be affected. If nuisance
tripping has occurred, and if the condition of the food appears
poor, dispose of it.
6
25"
(63.5 cm)
35"
(88.9 cm)
27"
(68.6 cm)
INSTALLATION
INSTRUCTIONS

Unpack the Refrigerator Drawers

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator drawer(s).
Failure to do so can result in back or other injury.
Remove the Packaging
Properly dispose of packaging. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the surface of your
refrigerator drawers.
Remove the Skids

IMPORTANT:

Always lay the appliance on its side when removing the skids.
Never place the appliance on its top. It may damage the
compressor.
Allow the appliance to sit on its rollers for 4 hours before
plugging into an electrical outlet.
1. Using two or more people, lay the appliance on its side.
2. Using a T30 TORX ®† screwdriver, remove the skids from the
bottom of the appliance. Discard the attachment bolts.
3. Using two or more people, turn the appliance upright on its
rollers.
When Moving Your Refrigerator Drawers:
Your refrigerator drawers are heavy. When moving the
appliance for service, be sure to protect the floor. Always
pull the appliance straight out when moving it. Do not
wiggle or "walk" the appliance when trying to move it, as
floor damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside of
your refrigerator drawers before using them. See the cleaning
instructions in the Use & Care Guide.
†®TORX is a registered trademark of Textron Innovations Inc.