Reinstall The Base Grille; Complete Installation - KitchenAid Standard Manual De Instalación

Reinstall the Base Grille

1. Be sure the Power On/Off Switch is on.
A
A. Power On/Off Switch (ON)
2. Reinstall the base grille.
NOTE: The bottom of the base grille has a notch and a wider
flange than the top.
A. Bottom flange
3. Using a Phillips screwdriver, drive the four screws into the
base grille as shown. Tighten all screws.
A
A
A
A. Screws

Complete Installation

1. Remove all boxes, parts packages and packing materials
from the interior of the refrigerator drawers.
2. Remove the protective film.
3. Clean the refrigerator drawers before use. See "Cleaning"
section in the Use & Care Guide for instructions.
4. The controls are preset at the factory to the default setting
38°F (3°C) for the upper and lower drawers. Be sure that the
compressor is operating properly and that all the lights are
working.
5. Reinstall the wire baskets in the refrigerator drawers. You can
install both wire baskets in the upper drawer, or, install one
wire basket in the upper drawer and the other wire basket in
the lower drawer.
6. If construction will continue after the refrigerator drawers
have been installed, turn the power Off for both Drawers. See
"Using the Controls" in the Use & Care Guide for instructions.
To get the most efficient use from your new refrigerator drawers,
read your Use & Care Guide. Keep these Installation Instructions
and Use & Care Guide near the refrigerator drawers for easy
reference.
11