Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Remove the Base Grille
IMPORTANT: You must remove the base grille in order to lower
the leveling legs. Be sure to reinstall the base grille when the
installation is complete.
1. Using a Phillips screwdriver, remove the four screws from the
base grille as shown.
NOTE: Do not discard the screws.
A
2. Place the base grille on a clean, soft working surface for
later use.
Install the Mounting Brackets
IMPORTANT:
Install two mounting brackets (upper and lower) on both sides
of the refrigerator drawers cabinet. The mounting brackets
secure the appliance to the adjacent cabinets.
To avoid the appliance pulling out of the opening when the
drawers are opened, secure the mounting brackets to the
adjacent cabinets.
The mounting bracket has an offset. Be sure when installing
the mounting brackets to position the offset to the adjacent
cabinets.
1. Begin installation (on each side) at the pre-drilled holes for the
upper mounting brackets.
NOTE: Insulation tape covers the top pre-drilled holes for the
upper mounting brackets. Do not remove the insulation tape
when installing the upper mounting brackets.
A
B
A. Pre-drilled top hole is
underneath the insulation tape
B. Pre-drilled holes
2. Using a Phillips screwdriver and one #8 x ¹⁄₂" pan-head
screw, drive the screw through the bottom hole of upper
mounting bracket and into the pre-drilled hole. Tighten the
screw.
3. Push a pan-head screw through the insulation tape and into
the pre-drilled hole. Tighten the screw.
A
A. Screws
4. Using a Phillips screwdriver and two #8 x ¹⁄₂" pan-head
screws, drive the screws through the holes in the lower
mounting bracket into the pre-drilled holes. Tighten the
screws.
5. Repeat the process for the other side.
6. Set aside the remaining eight #8 x ¹⁄₂" pan-head screws for
later use. See "Attach the Mounting Brackets to Adjacent
Cabinets."
Move the Refrigerator Drawers to
Final Location
IMPORTANT:
To avoid floor damage, make sure the levelers are raised (not
touching floor) and the weight of the appliance is on the
rollers before moving.
Rollers are for moving the refrigerator drawers and not for
permanent support.
1. Place top of cardboard carton or plywood under the
appliance. Remove dolly.
2. Do not remove protective film or cover.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug into a grounded 3 prong outlet.
4. Move the refrigerator drawers straight back and evenly in
front of the opening.
Lower the Leveling Legs
IMPORTANT:
All four leveling legs must contact the floor to support and
stabilize the full weight of the refrigerator drawers.
Rollers are for moving the refrigerator drawers and not for
permanent support.
To avoid cabinet/countertop damage, do not apply more than
50 inch–pounds (58 cm - kg) of torque to the leveling legs.
When leveling, be sure that the gap between the upper
drawer and the bottom edge of the countertop is a minimum
of ³⁄₈" (9.5 mm).
Style 2: Overlay—Be sure to install the custom overlay drawer
panels before leveling the refrigerator drawers. See "Style 2:
Install Custom Overlay Drawer Panels."
7
Tabla de contenido
