Installation And Connection - Oase PondoVac 5 Instrucciones De Uso

- EN -
Assembling the vacuum cleaner
Fitting the wheels
How to proceed:
 D
1. Insert the wheel into the wheel bush.
2. Firmly push the wheel until it locks into place.
Fitting the outlet
Prerequisite: The tank is open. (→ Opening/closing the tank)
How to proceed:
 E
1. Check the correct seating of the adapter with non-return valve.
– Ensure that the adapter is locked into place in the tank wall.
2. Screw the Storz coupling type C onto the outlet and hand-tighten.
Fitting the inlet
Prerequisite: The tank is open. (→ Opening/closing the tank)
How to proceed:
 F
1. Insert the intake distributor into the opening.
– Guide the pins on the intake distributor through the notches of the opening.
2. Twist the intake distributor to lock it into place (bayonet closure).
– Ensure that the outlet of the intake distributor in the tank is angled downwards.
3. Fit the debris collection bag onto the intake distributor in the tank.
– Ensure that the elastic of the debris collection bag is seated in the groove of the intake distributor.
– Secure the debris collection bag with the Velcro tape.

Installation and connection

 G
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Set up the unit at least 2 m away from the pond/pool.
• Ensure that the ground under the unit is firm and horizontal so that the unit cannot tip over.
N O T E !
The vacuum cleaner can be set up and operated in a position that is up to 0.3 m lower than the water level.
Possible consequences:
• When the vacuum cleaner is switched off, the water will automatically flow through the tank while the suc-
tion hose remains in the pond/pool. The pond/pool will be emptied.
Remedy:
• Always take the suction hose out of the pool/pond when the vacuum cleaner is switched off.
Adjusting the transport brace
How to proceed:
 H
1. Undo the locking screw.
2. Move the transport brace into the desired position.
3. Hand-tighten the locking screw.
20