Oase PondJet Eco Instrucciones De Uso página 16

- EN -
Product Description
Properties
· Floating fountain for flexible installation in ponds and lakes, suitable for all ground conditions.
· Multifunctional nozzle already integrated.
· Simple installation thanks to float function.
· Impressive water display with a height and width of up to 3 m.
· Additional nozzle patterns and lighting set available as accessories.
Environmental Function Control (EFC)
When started up, the pump automatically performs a pre-programmed self-test (Environmental Function Control
(EFC)). The pump detects if it is running dry / blocked or submerged. The pump switches off automatically after ap-
prox. 90 seconds if it runs dry/is blocked. In the event of a malfunction, disconnect the power supply and "flood the
pump" or remove the obstacle. Afterwards, the unit can be restarted.
Dynamic Function
Different values for the pump flow rates are pre-programmed in the pump control system to allow a dynamic fountain
pattern with changing heights and diameters. When the Dynamic Function is activated, the pump is continuously con-
trolled with these values.
Intended use
PondJet Eco, referred to as "unit", may only be used as specified in the following:
· For creating a water fountain in lakes or large ponds with or without fish.
· For aeration and supplying oxygen to garden ponds.
· Operate in accordance with instructions.
· Operation under observance of the permissible water quality. (® Water quality)
· For operation with clean water.
The following restrictions apply to the unit:
· Do not use in swimming ponds.
· Never use the unit with fluids other than water.
· Never run the unit without water.
· Do not use for commercial or industrial purposes.
· Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation
The unit must be completely assembled before it can be placed in the pond. Individual assembly steps:
· Fitting the nozzle body
· Fitting the pump
· Fitting the nozzle
Fitting the nozzle body
How to proceed:
5 B
1. Insert the nozzle body into the float.
2. Insert the screws with washers through the holes in the nozzle body.
– Ensure that the screws protrude from the bottom of the float.
3. Screw the self-locking nuts with washers onto the screws and tighten.
– Only tighten the screws until the nozzle body is fixed without play (do not overtighten).
16