Basic Programming - Pentair Evolio 5800 SXT 8 Manual Del Usuario

3. PM indicator
4. Flow indicator
5. x1000 indicator
6. Programming icon
7. Service icon
8. Error /
Information icon
5.2. Commands
1. Display
2. - Regenerate
3. - Up arrow
4. - Down arrow
5.3.

Basic programming

NOTE

Menus are displayed in a defined and incremental order.
NOTE

If no button is pressed for 5 minutes in the Programming mode (basic or master mode), or if there is
a power failure, the controller returns to Service mode and changes made are not saved.
MANDATORY
In order to save the new settings in the programming mode, it is necessary to go through all the
parameters.
Ref. MKT-UG-039 / A - 01.04.2020
→ Appears if controller set in US unit.
→ Flashes when outlet flow is detected.
→ Appears when the displayed number is bigger than 9999.
→ Appears in programming modes.
→ Appears in service mode;
→ Flashes if a regeneration cycle has been queued.
→ Appears in case of error, see page 15.
1
2 3
Used to show informations, see 5.1. Display, page 12.
Used to command the controller to regenerate.
Also used to change the lock mode.
Used to scroll up in a parameter list or to increment a parameter value.
Used to scroll down in a parameter list or to decrement a parameter value.

4
User Guide Evolio
13 / 116