Stenner M128 Serie Manual De Instalación Y Mantenimiento página 26

TUBE REPLACEMENT
H Place new tube
Cover Feet
I Install cover feet first
Prime Button
J Depress the prime button
Center of
Roller Assembly Cover Feet
K Align cover feet near bottom
L Expand roller assembly
®
M Apply Aquashield to cover bushing
26
INSTALL THE PUMP TUBE AND
EXPAND THE ROLLER ASSEMBLY
1. Ensure the power to the pump is off and the input
2. Place the new tube in the pump head, use your
3. Place the tube housing cover (feet first) on the tube
4. With the cover latched, plug the pump in. Depress
5. Unplug the power cord to ensure the power to the
6. Remove the tube housing cover and flip to use as
7. Align the center of the inverted cover with the center
3 Lugs
8. Hold the pump securely. Use the cover as a wrench
9. Apply a small amount of AquaShield
Cover
Bushing
10. Place the tube housing cover (feet first) on the
www.stenner.com
continued
signal is disconnected.
fingers to ensure that it centered over the rollers.
Illustration H
housing, affix the front of the latches to the cover lip
and then press the latches back to secure.
Illustration I
the prime button to allow the pump to run the roller
assembly in its collapsed position for one minute to
relax tube. Illustration J
pump is off.
a tool in the next step.
of the roller assembly so that the three holes on the
face of the cover align with the three knurled lugs on
the roller assembly. Position the cover feet near the
bottom. Illustration K
NOTE: The roller assembly needs to be expanded so
the tube is pressed against the tube housing wall.
and quickly (snap) rotate the roller assembly
clockwise to expand the roller assembly. The tube
will be pressed against the tube housing wall.
Illustration L
NOTE: Clockwise is viewed from facing the head of
the pump.
bushing ONLY. DO NOT lubricate the pump tube.
Illustration M
tube housing, affix the front of the latches to the
cover lip and then press the latches back to
secure. Illustration I
®
to the cover