Read This Chapter Before Using Various Functions; Getting Started; Turning On The Navigation System, And Displaying A Map - Clarion NAX943DV Manual De Instrucciones

ClarionNavi_English.book 4 ページ ２００４年３月１９日 金曜日 午後４時１８分

Read this chapter before using various functions

Getting started

Turning on the navigation
system, and displaying a
map
<Operation with the remote control>
1
Start the engine.
2
Push down the lever on the side (1), and
pull out the remote control (2).
3
If you want to change the language, tilt
the joystick in the way shown below, and
select the preferred language.
The indicator light shows which language
has been selected.
4
Press the button in the way shown
below.
If you find a sentence like "Select the
XXX key" hereinafter, select the spec-
ified key using the joystick, and press
the button.
5
Select the [ENTER] key.
E-4
6
After the operation, put back the remote
control on the holder.
Align the groove of the remote control to
the tooth of the holder (1). Push down the
remote control on the holder until it clicks
(2).
WARNING
• If you will not be using the remote con-
trol for a long time, remove the batter-
ies. They may leak and contaminate the
surrounding area.
• Always return the remote control to its
holder when not in use.
It may fall down to the floor, prevent
the driving operation, and can be a
cause of an accident.
CAUTION
Do not put the remote control in locations
exposed to direct sunlight or high tem-
perature and humidity. Doing so may
result in deformation, rupture of batter-
ies, or leakage.
Tips:
• If the SYSTEM START-UP screen is not
displayed, follow the procedure below.
- The touch panel model
Press the button, and select one of
the following keys.
[NVG MODE]
[NVG+BGM MODE]
- The remote control model
Refer to the operation manual of your
monitor.
• Modes
[NVG MODE] Navigation mode:
The navigation screen is always dis-
played and voice guidance is heard.
[NVG+BGM MODE] Navigation+BGM