Tabla de contenido
2.
Install Brackets
Y
Z
X
29-7/8"
(75.9 cm)
5" (12.7 cm)
NOTICE: The mounting brackets are attached to the back of the unit. Prior to
removing the mounting brackets, several dimensions must be recorded to ensure a
successful installation. Use the table below to record these measurements.
Measurement Description
Outside edge of vanity to outside edge of left bracket
Outside edge of vanity to outside edge of right bracket
Outside edge of left bracket to outside edge of right bracket
Locate the 2x12 backing material.
Measure and mark 29-7/8" (75.9 cm) from the floor to the desired center location
of the vanity.
Using a level, draw a horizontal line the length of "Z" through the marked height.
This will note the horizontal position where the vanity will slide onto the brackets.
Using a level, measure and mark the distance of "X" and "Y" from each respective
edge of the horizontal line "Z". This will note the top edge of each bracket.
Mark a 5" (12.7 cm) plumb line down from the previous marked point. This will
note the outermost edge of each bracket.
NOTE: A left side bracket and a right side bracket are provided. Ensure that you are
aligning the correct bracket before marking its location.
Remove the brackets from the vanity.
Align the outermost edge of each bracket at the side mark and the top edge of the
bracket at the horizontal mark.
Mark the mounting hole locations of the bracket on the finished wall. Set the
brackets aside.
Drill the marked holes using a 3/16" drill bit.
Secure each bracket to the finished wall using 5/16" ID flat washers (not
provided) and lag bolts (not provided).
Verify the brackets are level.
Kohler Co.
5" (12.7 cm) Plumb Line
Ligne droite de 5" (12,7 cm)
Línea a plomo de 5" (12,7 cm)
Finished Wall
Mur fini
Pared acabada
Verify brackets are level after mounting.
Vérifier que les supports sont nivelés après le
montage.
Verifique que los soportes estén a nivel después
del montaje.
Variable
X =
Y =
Z =
9
Measured
Distance
________
________
________
1082756-2-A
Tabla de contenido
