Tabla de contenido
4.
Install the Lavatory
Install the faucet (if applicable) and drain to the lavatory. Refer to the faucet and
drain manufacturer's installation instructions.
With assistance, lift and properly position the lavatory on top of the vanity.
Verify each drawer opens and closes with ease.
With assistance, remove the lavatory from the vanity. Set the lavatory aside.
If necessary, adjust the height of each drawer. Refer to the "Drawer and Shelf"
section to properly adjust the height.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
Run a 1/4" (6 mm) continuous bead of siliconized acrylic caulk around the top of
the vanity, as illustrated.
CAUTION: Risk of personal injury or product damage. Vitreous china lavatories
are very heavy. Get help lifting and aligning the lavatory.
NOTE: The lavatory is properly positioned when: (1) the back edge of the lavatory is
flush against the finished wall and (2) the overhang on the left, right, and front side
of the lavatory is equal on each side of the vanity.
With assistance, lift and properly position the lavatory on top of the vanity.
Immediately wipe away any excess caulk that contacts the vanity.
Run an 1/8" (3 mm) bead of siliconized acrylic caulk along the top edge of the
lavatory where the lavatory contacts the finished wall.
Installer le lavabo
Installer le robinet (si applicable) et le drain au lavabo. Se référer aux instructions
d'installation du fabricant du robinet et du drain.
Avec de l'assistance, soulever et positionner correctement le lavabo au-dessus du
meuble.
Vérifier que chaque tiroir ouvre et ferme aisément.
1082756-2-A
14
Kohler Co.
Tabla de contenido
