Klarstein Botella 166 Uno Manual Del Usuario página 36

EN
36
• Remove the upper hinge cover and remove the four screws that are used to fix the
upper hinge to the cabinet top.Then remove the upper hinge and install it at the
designated position on the left side.
• Set the glass door to the designated position and install the two lock screws to
connect the door shaft assembly with the glass door and tighten them before the
door is levelled.
• Remove the handle from the left side of the door and install it on the right side.
Caution: Check that the door opens and shuts correctly, without fouling, after you
have completed the door reversal process.
After the door has been reversed, you should check the door seal of the wine cooler. The
seal should not be creased or crushed; otherwise there will be a gap between it and the
inside of the door. The seal must adhere properly all the way around the door. If the seal
is not adhering to the cabinet properly, then you should either:
• Use a warm damp cloth and manipulate the seal until it does adhere to the cabinet
properly, all the way around the door, or
• Use a hair dryer on its lowest heat setting and lightly heat the areas of the door seal
that are not adhering correctly. The heat will make the seal more pliable and this will
allow you to manipulate the seal into the correct position.
Caution: Do not heat the door seal on anything but the lowest heat setting, or heat
the seal for a long period of time. Otherwise damage may be caused to the door
seal, which would not be rectified under the guarantee free of charge. When you
have reversed the door of the appliance, if you have placed the appliance on its
back, you must wait for 8 hours before switching the appliance back on.