Utilitech 7115-03 Manual De Usuario página 9

EXISTING CONSTRUCTION ASSEMBLY INSTRUCTIONS
3. Remove the three screws (3.1) that hold the motor
assembly (3.2) in place. Remove the fan motor
assembly (3.2) from the fan housing (A). Unplug the
fan power unit (3.3).
4. Remove the wiring box cover (4.1) from the fan
housing (A). Remove the wiring knockout (4.2) from
the wiring box cover (4.1) with a flathead screwdriver
(not included).
5. Pull the house wires through the wire box cover hole.
Secure 120 V AC house wiring from the wall switch
to the fan as shown in the wiring diagram on page 5.
14 AWG is the smallest conductor that should be used
for branch-circuit wiring.
Carefully push the connected wires back into the wiring
box housing. Reattach the wiring box cover.
CAUTION: If the electrical wires do not match the
colors listed, you must determine what each house wire
represents before connecting. You may need to consult
an electrical contractor to determine safely.
3
4
4.1
5
House
wires
9
3.3
3.2
3.1
A
4.2
Wire nut
(not included)
Product
wires
A