Before The First Usage; First Steps; Setting Up The Appliance; Adjust The Infinite Slice-Thickness Setting (See Fig. D) - Silvercrest SAS 150 A1 Instrucciones De Utilización Y De Seguridad

Safety / Before the First Usage / Operation
U se the appliance with the supplied accesso-
ries only. No claims under the warranty nor a
liability for damages will be accepted if they re-
sult from improper or incorrect use of the slicer.

Before the First Usage

Q

First steps

Q
C arefully remove the electric Multi-Purpose
Slicer from its packaging, remove all packag-
ing materials and keep them together with the
main packaging.
C lean the electric Multi-Purpose Slicer before it
comes into contact with any foodstuffs (see also
the chapter "Cleaning").

Setting up the appliance

Q
Specific safety advice on the
placing of the appliance
1. Never set the electric Multi-Purpose Slicer up
on a hot surface or near an open flame.
2. Ensure that the power cable
over hot or sharp-edged objects.
3. Do not allow the power cable
kinked or trapped and do not wrap it around
the electric Multi-Purpose Slicer.
S et the electric Multi-Purpose Slicer up on a
flat, non-slip surface close to a power socket.
U nwind the required length of power cable
Insert the plug into the power socket.
P lace the food carriage
table with guide slot
press the on the blade cover
side down, so that the holding clamps (on the
underside of the food carriage
sure that these have correctly engaged, in that
you check the mobility of the food carriage. Pull
to the front for removal of the food carriage
from the guide slot
port table .
9
P ush the food holder plate
carriage .
10
32 GB/MT
does not pass
8
to become
8
on the supporting
10
(see Fig. B). Now
9
high standing
6
) engage. En-
10
and lift it from the sup-
9
on to the food
11
P lace the catch tray
table and on the housing such that the
9
sliced foods can fall in there directly and with-
out hindrance after being cut.
Adjust the infinite slice-thick-
Q
ness setting (see Fig. D)
Through variable tightenings of the adjusting
screws you can determine the movement rate
16
of the infinite slice-thickness setting
S crew both of the adjusting screws
with the screwdriver
C heck, by turning the infinite slice-thickness
control knob
rate is suitable.
If it is not,
- loosen both adjusting screws
movement rate or
- tighten both adjusting screws
stiffer movement rate.
operation
Q

Working advice

Q
Specific safety advice for
slicing and for the handling of
the appliance
1. Never touch the cuttingblade
. er is in operation!
8
There is a risk of grave personal injury!
2. Always use the food carriage
holder plate
of foodstuff).
Press the pieces of food to be sliced forward
using the food holder
3. Use the slicer only for cutting normal house-
hold foods and not for other purposes. Do not
use the slicer for cutting deep-frozen foods,
10
bones, foods with large kernels or for the
slicing of still packaged foods.
4. Never use the slicer continuously for more than
10 minutes .
below the support
17
.
14
16
.
15
, to see if the desired movement
14
for a lighter
16
further for a
16
when the slic-
12
and the food
10
(Exception: very large pieces
11
.
11
tight