Assembly Of Drive Rollers; Welding - CEA COMPACT 410 Manual De Instrucciones

V. 220/230/240
Blu-Bleu-Blue-Blau
Rosso-Red-Rouge-Rot
V. 380/400/415
Blu-Bleu-Blue-Blau
Rosso-Red-Rouge-Rot
FIG. B
1
2
FIG. D
FIG. E
FIG. C
FIG. F
FIG. G
Unscrew the ring nut (Pos. 6, Fig. G). Lift up the arms holding
the idle roller (Pos. 2, Fig. G) and proceed as follows:
• Each roller shows the type of wire and diameter on the two
external sides.
• Install the right rolls (Pos. 3, Fig. G) making sure the groove
is in the correct position for the diameter of the wire being
used.
• Screw up the ring nut again (Pos. 6, Fig. G).
IMPORTANT: Before welding, check that the data on the power
source plate correspond to the supply voltage and frequency.
• Start up the welder by turning the scaled change-over switch
(Pos. 1, Fig. F) to position 1.
• The green LED (Pos. 3, Fig. F) lights up to show that the
welder is working and ready to use.
3
• Turn the welding voltage switch (Pos. 11, Fig. F) to the most
suitable position for the work to perform.
• Remove the gas-guide and wire-guide nozzles, allowing the
wire to flow freely during loading. Remember that the con-
tact tip must correspond to the wire diameter.
• Set the wire speed potentiometer on position 3 (Pos. 9,
Fig. F).
• Push the torch push button or the motor check push button
until the wire end comes out from the torch.
• Tighten the contact tip on the torch.
• Attach the correct gas-guide nozzle.
11
3
1
2
10
11
9
5
2
8
9
4
3
6

Assembly of drive rollers

Welding

4
5 6
7
8
2
8
1
3
7