TSI 8495 Manual De Operación Y Servicio página 15

Setting Up the Transducer Display & Monitor
The Model 8495 Transducer Display & Monitor displays an output
that is linearly proportional to the input signal.
When the Transducer Display & Monitor is first turned on it will scroll
through the current settings for the signal input, full scale, and time
constant. The Transducer Display & Monitor comes with the
parameters set to the default values found in the following table.
Time Constant
Full Scale
Signal Input
Zero Adjust
Span Adjust
Low Alarm
High Alarm
LEDs
Relays
Audible Alarm
C
ERTIFIER
The SET key is used to change (or view) the settings of the above
parameters. By pressing the SET key repeatedly, the parameters can
be changed (or viewed). Each time the up and down arrow keys
() are used to change a value the SET key must be pressed to
advance to the next parameter.
Full scale
Signal input
Factory Settings
®
The full scale can be adjusted by pressing the up
and down arrow keys (). The available values
are: 0.1000 to 99990.
The signal input can be adjusted by pressing the up
and down arrow keys (). The available choices
are: 0–5 VDC, 0–10 VDC, 1–5 VDC, 2–10 VDC, 0–
20 mA, 4–20 mA. For 0–20 mA or 4–20 mA settings,
use the provided jumper to short the MA SIG+
terminal to the 5V SIG+ terminal.
1
10000
0–5 V
0
1.000
Off
Off
Unlatched
Unlatched
Off
Off
–7–