Vitrifrigo CENTER COOLER Manual De Instalación página 25

The cooling
power of the
refrigerator is not
enough
171209 – rev. 01 08/18
Refrigerant
pipes
Door closure
Position
Condenser
Defrosting
General
Make sure that the pipes and/or
components of the refrigerant circuit
are not touching. This is a check that
must only be carried out by a
specialist service technician
Make sure that the door is correctly
closed and also that the gasket is not
damaged in any point
Make sure that the refrigerator is not
too close to heat source
Make sure that the refrigerator is
positioned so that the condensation
air can be discharged correctly (from
the rear panel)
Make sure that the condenser fan is
rotating correctly
Check the condenser for dust and
clean if necessary
Make sure that the insides of the
refrigerator are not covered in ice.
Defrost if necessary
Make sure that only precooled milk is
filled in
Do not place any hot or warm
container in the cooler (danger of
breaking inner liner)
Make sure that the milk hose does
not touch the inner liner walls.
EN