Positioning - Vitrifrigo CENTER COOLER Manual De Instalación

7.2 Positioning

The refrigerator has the overall dimensions in millimetres (in inches)
shown in the figure below.
Fig.2
Place the refrigerator on a horizontal surface.
When choosing the position of the refrigerator, remember that a gap of at
least 100 mm (4 in.) is required between the back panel of the refrigerator
and any wall to allow the warm air from condensation to escape.
We recommend leaving a gap of the same size 100 mm (4 in.) between
the top part of the refrigerator and any surface above it.
As far as any space requirements at the sides of the refrigerator are
concerned, there are no specific instructions.
171209 – rev. 01 08/18 EN