Grounding Instructions - Ingersoll Rand ELB2612N Especificaciones Del Producto

Grounding Instructions

The tool should be grounded while in use to protect the operator from electric shock. The tool
is equipped with a three-conductor cord and three-prong grounding-type plug to fit the proper
grounding-type receptacle. The green (or green and yellow) conductor in the cord is the
grounding wire. Never connect the green (or green and yellow) wire to a live terminal. If your
unit is for use on less than 150V, it has a plug that looks like that shown in Figure A. An adapter
(see Figure B) is available for connecting Figure A-type plugs to 2-prong receptacles. The
green colored rigid grounding strap must be connected to a permanent ground such as to a
properly grounded outlet box as shown in Figure C.
(Dwg. TPD446-1)
For safe use of adapters, the outlet box must be grounded. If there is any doubt, have a
qualified electrician check connections.
Use only 3-wire extension cords that have 3-prong grounding type plugs and 3 pole
receptacles that accept the plug. Replace or repair damaged cords.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
45549110_ed1
FIGURE A
Grounding
Blade
Adapter
FIGURE B
WARNING
Cover of
FIGURE C
Grounded
Outlet Box
Grounding Means
EN
EN-4